HP | Java App block after update on switch web page

When I upgraded to the latest JAVA version 8.25 I figured out that I was unable to view the switch information via the web browsers. I received the following warning To solve this issue you have to do the following. Go to the Java Configuration Console Go to Security Go to Edit Site List Add … Continue reading HP | Java App block after update on switch web page

HP Procurve Switch | Recover boot sequence after removing boot.ini in the Monitor ROM Console.

If you have HP Procurve 2910al switches in the serial number range Than you will face the issue that you aren’t able to upgrade to Firmware version 15.x Via the HP support my collegue got the following commands to try to solve this issue. In boot monitor mode : 0. Monitor ROM Console 1. Primary … Continue reading HP Procurve Switch | Recover boot sequence after removing boot.ini in the Monitor ROM Console.

HP Procurve 2910 Switch (routing configuration)

1:     login to the switch through TELNET OR SSH 2:    Standard configuration does not contain a password 3:    type configure terminal 4:    type a hostname "name of the switch". 5:    Type vlan 1 and configure an ip address 6:    Enter a default gateway 7:    type ip routing & default route "ip route 0.0.0.0 0.0.0.0 x.x.x.x" When you enable routing, and default … Continue reading HP Procurve 2910 Switch (routing configuration)

HP Procurve switches and the use of auto-stacking

Some of the readers will probably already know that the HP Procurve switch lines has an stacking command to add new switches into the stacking group. The only thing you will need is that one of the switches is the Stack Commander. To configure a switch as stack commander. you will need the first command … Continue reading HP Procurve switches and the use of auto-stacking

Netgear Readynas 3200 2LAN connection to HP Procurve 2810-XX Switch

How to configure a Netgear Readynas 3200 with 2 lan connections to a HP Procurve 2810-24 or 48 switch. To configure a Netgear Readynas 3200 with 2 lan ports to an HP Procurve 2810-24/48 switch. On the Netgear Readynas 3200 you have to set the LAN connections too. At the tab Ethernet 1 you can … Continue reading Netgear Readynas 3200 2LAN connection to HP Procurve 2810-XX Switch

Switch configuration for Trunk to ESX

I noticed from an installation which i made for trunking between a HP Procurve switch and some ESX servers. So after some weeks with issues I found a solution to get rid of Dropped TX packets. The following you will need to configure on your Switch. ( i used a HP Procurve switch 4208GL ) … Continue reading Switch configuration for Trunk to ESX